136 Results
View results:
Sort by:
Setting of I-Beam Flange Support for Design in Structure Stability Add-on
In the Steel Design add-on, I have set the boundary conditions in such a way that the I-beam flange is restrained against the horizontal displacement. I then calculated the critical load factors using the Structure Stability add-on, but with no effect on the critical load factor value. What is the reason for this?
Incorrect Material or Cross-Section Conversion in Revit or Tekla
I get an incorrect conversion in Tekla/Revit when using regular expressions in the conversion table.
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way in RFEM 6?
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way?
What are Line Hinges and Line Releases?
Adding New Load Case to Automatically Generated Combination
I design pipelines using the RF-PIPING Design add-on module. I have created a new prestress load case and loaded the piping with longitudinal displacement.
Is it possible to add this new load case to combinations that are generated automatically?
Splice Connection
How do I create a splice connection in the Steel Joints add-on?
Elastic Nodal Support with Python
How can I create an elastic nodal support using the Python program?
Reading out Nodal Deformation with Python
How can I read out the deformation at a certain node using the Python program?
Creating Nonlinear Line Hinge with Python
How can I create a nonlinear line hinge with the Python program?
Earthquake Data in Geo-Zone Tool According to DIN EN 1998
How does the Geo-zone tool determine the earthquake data according to DIN EN 1998‑1?
RFEM and RSTAB Not Starting with 3D Mouse
RFEM and RSTAB crash at the moment of starting the program. I work with a 3D mouse. Where is the problem?
Creating Response Spectrum ASCE 7-22
How can I create a response spectrum according to ASCE 7‑22?
Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?
Why does the load wizard "Member Load from Area Load" give unnecessary concentrated loads?
Geographic Coordinates by Longitude and Latitude
In which format should I enter the geographic coordinates by longitude and latitude in the online service?
Units and Decimal Places
How can I permanently save the parameters in the "Units and Decimal Places" dialog box?
Normalization of Mode Shape
Where can I adjust the normalization of a mode shape in RFEM 6 / RSTAB 9?
Printout Report Template
How can I create standardized printout reports in RFEM 6 and RSTAB 9 and use them as a template on other computers?
- 005113
- Timber Design for RFEM 6
- Timber Design for RSTAB 9
-
- Aluminum Design for RFEM 6
- Aluminum Design for RSTAB 9
- Steel Design for RFEM 6
- Steel Design for RSTAB 9
- Stress-Strain Analysis for RFEM 6
- Stress-Strain Analysis for RSTAB 9
- Steel Joints for RFEM 6
- Timber Structures
- Concrete Structures
- Steel Structures
- Structural Analysis & Design
- Eurocode 2
- Eurocode 3
- Eurocode 5
- Eurocode 9